Panasonic WV-CU360C manual Setup Procedures, Administrator Authorization

■Setup Procedures

Set up the baud rate and parity check mode for the controller while observing the LED on the front panel.

Menu		Setup Menus			Parameter Selection (default*)
	LED Display	Reading	Function
Selection
				CAM
		Setup	Initial		LED prompts you to enter pass-
			Display		word
				SET
No					Enter a 5-digit password,
		Administrator	Authorization		press CAM (12345*)
OK		Password
	blinking	Prompt
					SET
				Press
Move Joystick			Baud Rate	twice	(1) 2 400 (2) 4 800 (3) 9 600*
		Speed
UP and down
			(bps)	CAM	(4) 19 200
to select
L	R			SET
DOWN				MON
UP		Parity	Parity Check		(1) None* (2) Even
L	R
				ESC

●Administrator Authorization

1.Press the CAM/SET button while [SEtUP] is displayed. The [- - - - -] prompt appears.

2.Enter a password using the numeric buttons, then press the CAM/SET button.

The default setting is [12345].

3.If the password entered is valid, [SPEED] appears. If password entry failed, the menu returns to [SEtUP].

Note: Selecting a slower rate (e.g., 2 400 bps) will delay the response time (e.g., the time until an acti- vated alarm is reset).

3.Press the CAM/SET button to validate the selection.

4.Press the MON/ESC button to return to the [SPEED] menu.

●Parity

The parity check mode is selected in this menu.

●Baud Rate

When bit 7 of the MODE switch is in the ON position, you need to select the communication speed manually to match that of the WJ-SX350.

1.Display [SPEED], and press the CAM/SET button twice.

2.Select a parameter entering a bracket-enclosed num- ber, e.g., (3), or moving the joystick.

The default setting is 9 600 bps.

(1)2 400: 2 400 bps

(2)4 800: 4 800 bps

(3)9 600: 9 600 bps *

(4)19 200: 19 200 bps

1.Display [PrtY] and press the CAM/SET button twice.

2.Select a parameter with the joystick. The default setting is None.

n:None

E:Even parity

3.Press the CAM/SET button to confirm the selection.

4.Press the MON/ESC button to return to the [SPEED] menu.

Note: The baud rate and parity check mode of the WJ- SX350 and the controller must be the same, otherwise data communications will not function.

61