Unit a button Assignment, User Password

●Unit A button Assignment

In this menu, a maximum of 9 system units is assigned to numeric buttons 1-9 regardless of unit address.

This is to avoid double-digit unit addresses which can occur in a large system with many units connected and could confuse operators.

A frequently used system unit can be easily selected in nor- mal operation by pressing one numeric button and then the UNIT A button.

1.Display [UA-no] and press the CAM/SET button. The LED displays [A1-01] while “1” following A blinks.

The first 2 digits from A1 to A9, “A numbers”, stand for numeric buttons from 1 to 9 to be pressed prior to UNIT A button in normal operation. The next 2 digits are the unit address assigned in the following procedures.

The default setting is shown below.

A1-01

A2-02

A3-03

A1-04

A5-05

A6-06

A7-07

A8-08

A9-09

2.Select an “A number” entering a number from 1 to 9, then press the CAM/SET button. The LED displays “A number” A3 when numeric button 3 is entered for example.

Available A numbers: 1-9

3.Press the CAM/SET button to validate the selection. The LED displays [A3-03] while the next two digits are blink- ing.

4.Enter a 2-digit unit address that you wish to assign to the “A number” (e.g., A3), then press the CAM/SET but- ton. The LED displays [A3-99], for example, when you enter unit address 99.

Available addresses: 01-99

5.Press the CAM/SET button to validate the selection. Repeat above the steps 2 to 5 as needed.

6.Press the ESC button to go back to the previous menu.

●Unit B button Assignment

The UNIT B button is set up in the same way as the UNIT A button for use in normal operation. Refer to the above description for Unit A button Assignment.

●User Password

In this menu, a 5-digit password for user authorization is registered.

1.Display [UsrP ] and press the CAM/SET button. The LED displays the registered password.

2.Enter a 5-digit password with the numeric buttons. The default setting is [12345].

Available password digits: 00000-99999

3.Press the CAM/SET button to validate the selection.

4.Press the ESC button to go back to the previous menu.

●Administrator Password

In this menu, a 5-digit password for administrator certifica- tion is registered.

1.Display [SUsrP] and press the CAM/SET button. The LED displays the registered password.

2.Enter a 5-digit password with the numeric buttons. The default setting is [12345].

Available password digits: 00000-99999

3.Press the CAM/SET button to validate the selection.

4.Press the ESC button to go back to the previous menu.

●User Password Certification

In this menu, password certification in normal operation is enabled or disabled.

1.Display [USr-C] and press the CAM/SET button. The LED displays [UC-on] or [UC-oF].

2.Select On or Off with the joystick controller. The default setting is On.

on: Password certification enabled.

oF: Password certification disabled.

3.Press the CAM/SET button to confirm the selection.

4.Press the ESC button to go back to the previous menu.