Panasonic WV-CU360C manual System Unit Selection, Selecting with Unit Number

■System Unit Selection

Connected system units can be selected either by their unit number (01-99) or by a single-digit number (1-9) assigned to the UNIT A or UNIT B button.

●Selecting with Unit Number

1.Enter a unit number (01-99) with the numeric buttons.

●Selecting with UNIT A/UNIT B Button

The unit numbers (01-99) of some frequently used units can be assigned to numeric buttons 1-9 in the setup. Units can be divided in two groups, one assigned to the UNIT A and the other to the UNIT B button. A frequently used system unit can be easily selected by pressing one numeric button and then the UNIT A or UNIT B button.

1.Enter a single digit number (1-9).

Omit this step when you wish to select unit number “1”, as this unit is selected by default.

MONCAM

ESC LOGOUT SET

2.Press the SHIFT button to turn the shift indicator on, then press the UNIT A/UNIT button.

UNIT A

then

SHIFTUNIT

The selected unit number appears in the unit section of the LED display.

The selected camera number appears in the camera section of the LED display.

Notes:

•To confirm the selected unit number when the moni- tor number appears in the unit section of the LED display, take procedure 2 or press MON/ESC but- ton .

•If no unit is connected, [Err] appears a few seconds after unit selection. In such a case, confirm the unit address and repeat the above procedure.

•If the unit address of a system unit is unknown, con- sult your system administrator.

•When multiple system units such as Data Multiplex Unit are connected to the System Controller and the UNIT A or UNIT B button is pressed, the camera number on the controller's LED display will not agree with the camera picture on the monitor.

In this case, select the monitor and camera as described on the next page.

MONCAM

ESC LOGOUT SET

2.Press the UNIT A or UNIT B button while the SHIFT indicator is off.

UNIT A UNIT B

or

UNIT

The selected unit address appears in the unit section of the LED display.

The selected camera number appears in the camera section of the LED display.

24