Configure the settings relating to the host authentication [Host auth.]
Click the [Host auth.] tab on the "User mng." page. (☞ Pages 13 and 14: How to display/operate the setup menu) The restriction settings of PCs (IP address) from accessing the camera can be configured on this page.
[Host check]
By clicking [C] of "Host check", the registered host can be selected and the selected host’s IP address can be checked.
The registered IP address will be displayed with the access level.
(Example: 192.168.0.21 [1])
To delete the registered host, click the [Delete] button after selecting the IP address to be deleted.
[Host auth.]
Select "On" or "Off" to determine whether or not to authenticate the host.
Default: Off
[IP address]
Enter the IP address of the PC to be allowed to access the camera. Host name cannot be entered for the IP address.
Note:
•When "IP address/subnet mask" is entered, it is possible to restrict PCs in each subnet. For exam- ple, when "192.168.0.1/24" is entered and "2. Camera control" is selected for the access level, the PCs whose IP address is between "192.168.0.0" - "192.168.0.255" can access the unit with the access level "2. Camera control".
•When the IP address already in use is entered and the [Set] button is clicked, the respective host infor- mation will be overwritten.
[Access level]
Select the access level of the host from the following.
1.Administrator/ 2. Camera control/ 3. Live only Refer to page 38 for further information about the access level.
Default: 3. Live only
39