Maytag MAH-24 Open and close the door, then press the Start/Pause pad

Troubleshooting•
The washer will not start	•	Make sure door is firmly closed.
	• Make sure the washer is plugged in.
	• Make sure the water source faucet is turned on.
	• Make sure to press the Start/Pause pad.
	• Make sure the Child Lock is not activated, see page 6.
No water or insufficient		Turn both faucets on fully.
water supply	•	Make sure the door is tightly closed.
	• Make sure the washer is plugged in.
	•	Check fuse or reset circuit breaker.
	•	Press the Start/Pause pad.
	•	Straighten water inlet hoses.
	•	Disconnect hoses and clean screens. Hose filter screens may be plugged.
	•	Open and close the door, then press the Start/Pause pad.
Detergent remains in the	•	Make sure the washer is running with sufficient water pressure.
automatic dispenser after the		See Installation Instructions.
wash cycle is complete	•	Put the detergent in the inner parts of the dispenser
		(away from outside edges).
Washer vibrates or is too noisy	•	Make sure the washer is set on a level surface. If the surface is not level,
		adjust the washer feet to level the appliance.
		See Installation Instructions.
	•	Make sure that the shipping bolts are removed.
		See Installation Instructions.
	• Make sure the washer is not touching any other object.
	• Make sure the laundry load is balanced.
Stops	•	Plug cord into live electrical outlet.
	•	Check fuse or reset circuit breaker.
	• Close door and push the Start/Pause pad to start the washer.
		For your safety, the washer will not tumble or spin unless the door is
		closed.
	• This may be a pause or soak period in the cycle.
		Wait briefly and it may start.
	•	Check screens on inlet hoses at the faucets for obstructions.
		Clean screens periodically.
		Continued...

12