Kenmore I10.8809, I10.8808 manual Dryer Care

Page 25

Suggested

Items for Rack

Cycle

Suggested

Drying

 

 

Setting

Time*

 

 

 

 

 

(Minutes)

Washable

wool items

Low

20

(block to shape and lay flat

 

 

on dryer

rack)

 

 

Stuffed

toys

or pillows

Low

30

(cotton

or polyester

 

 

fiber filling)

 

 

 

Stuffed

toys

 

Air Dry

50

(foam

rubber filled)

 

 

Galoshes

(rubber)

Air Dry

20

Foam

rubber pillows

Air Dry

50

Tennis shoes

Air Dry

20

*Reset time as needed to complete drying.

NOTE: You must remove dryer rack for normal tumbling. To remove the dryer rack, lift it straight up and out of the dryer.

DRYER CARE

Keep dryer area clear and free from items that would obstruct the flow of combustion and ventilation air.

Explosion Hazard

Keep flammable materials and vapors, such as gasoline, away from dryer.

Place dryer at least 18 inches (46 cm) above the floor for a garage installation.

Failure to do so can result in death, explosion, or fire.

.... ng rise Li/ t Sc'ees

Every load cleaning

The lint screen is located in the door opening of the dryer. The control panel has an indicator light to remind you to clean the lint screen before each load, A screen blocked by lint can increase drying time.

To clean

1.Pull the lint screen straight up, Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove.

2.Push the lint screen firmly back into place.

IMPORTANT:

Do not run the dryer with the lint screen loose, damaged, blocked, or missing. Doing so can cause overheating and damage to both the dryer and fabrics.

If lint falls off the screen into the dryer during removal, check the exhaust hood and remove the lint, See "Venting Requirements."

As needed cleaning

Laundry detergent and fabric softener residue can build up on the lint screen. This buildup can cause longer drying times for your clothes, or cause the dryer to stop before your load is completely dry, The screen is probably clogged if lint falls off while the screen is in the dryer.

Clean the lint screen with a nylon brush every 6 months, or more frequently, if it becomes clogged due to a residue buildup.

To wash

1.Roll lint off the screen with your fingers.

2.Wet both sides of lint screen with hot water.

3.Wet a nylon brush with hot water and liquid detergent. Scrub lint screen with the brush to remove residue buildup.

4.Rinse screen with hot water.

5.Thoroughly dry lint screen with a clean towel. Replace screen in dryer.

To clean dryer drum

1.Make a paste with powdered laundry detergent and very warm water.

2.Apply paste to a soft cloth.

OR

Apply a liquid, nonflammable household cleaner to the stained area and rub with a soft cloth until all excess dye and stains are removed,

3.Wipe drum thoroughly with a damp cloth.

4.Tumble a load of clean cloths or towels to dry drum.

NOTE: Garments that contain unstable dyes, such as denim blue jeans or brightly colored cotton items, may discolor the dryer interior. These stains are not harmful to your dryer and will not stain future loads of clothes. Dry unstable dye items inside out to avoid transfer of dye.

25

Image 25
Contents Electric Dryer Table of Contents ONE Year Limited Warranty Kenmore Elite Appliance WarrantyProtection Agreements Master Protection AgreementsYour safety and the safety of others are very important Dryer SafetyParts supplied 80O-4-MY-HOM E If using a power supply cordParts needed You will needMobile Home Additional Installation Requirements Installation ClearancesIt is your responsibility Electrical Connection If connecting by direct wireIf your outlet looks like this Ecb ca Direct WireWire connection Power supply cord Style 2 Direct wire strain reliefWire connection Direct Wire CG F Optional 3-wire connection If this is a new vent system Vent material If using an existing vent systemExhaust Rigid metal ventSpecial provisions for mobile home installations Optional exhaust installationsDetermine vent path Vent system chartNumber Type Box or Angled G0 turns Vent Louvered Hoods Hoods Rigid MetalEc, ne ,-@se Remove the door assembly If the dryer will not start, check the following To use an Auto Dry Cycle Dryer USETo stop or pause your dryer at any time To use a Timed CycleDrying tips Cycle tipsAuto Dry Cycles Heavy Duty SteamCare Preset Cycle SettingsUltra Delicate Express DRY TMAuto Dry Cycle Modifiers Changing Modifiers and Options after pressing Start Changing the Preset Dryness Level SettingsTo use the dryer rack Dryer Care For direct-wired dryers Dryer displaying code message TroubleshootingNo heat UnusualsoundsAre fabric softener sheets blocking the grille? Is the lint screen clogged with lint?Is the exhaust vent the correct length? Has the Air Dry modifier been selected?Odors Loads are wrinkledLint on load Is the lint screen clogged? Is the dryer being used for the first time?Contratos DE Proteccion Garantia Limitada DE UN Aiio Seguridad DE LA SecadoraExclusion DE Garantias Implcitas Limitacion DE Recursos Piezas suministradas Instrucciones DE InstalacionPiezas necesarias Peligro de Explosion Si emplea un cable de suministro elctricoUsted necesitara Las instalaciones en casas rodantes necesitan Usted es responsable deConexibn elctrica Si el contacto de pared luce como steSi hace la conexi6n con cableado directo Si el contacto de pared luce come steCable de suministro elctrico Cable directo Con Estilo 2 Protector de cables para cable directoConexibn de 4 hilos Cable de suministro elctrico Conexibn de 4 hilos Cable directo CG F Conexibn opcional de 3 hilos Codos Ducto de escape de metal flexibleAbrazaderas Ventilaci6nPeligro de Incendio Instalaciones opcionales de escapeDe 90 o Caja o tipo Codos Persiana No. de Tipo de ducto Capotas de Vueltas Ventilaci6n deDeterminacibn de la via del ducto de escape Cuadro del sistema de ventilacibnRe& c de C6mo invertir el tope Si la secadora no funciona, revise Io siguiente Peligro de Explosi6n USO DE LA SecadoraSistema de secado de doble acci6n Para usar un ciclo de secado automatico Auto Dry Cycle Para hacer cambios durante un ciclo de secado automaticoPara usar un Ciclo con vapor SteamOare Cycle Para usar un ciclo programadoSugerencias de secado Para reanudar la marcha de la secadoraSugerencias de ciclos Mojado WetTowels Ciclos de secado autombticoNormal Secado expreso Express DRY TM Ciclos programados Timed CyclesAjustes prefijados de ciclos programados Modificadores del ciclo de secado autombticoSerial de ciclo Cycle Signal Serial de semi seco Damp Dry SignalSecado al aim Air Dry Tipo de carga TiempoCbmo cambiar los ajustes prefijados de nivel de sequedad Cambio de ciclos despu6s de presionar Inicio StartPara limpiar Limpieza de cada cargaImportante Limpieza segun la necesidadEn el interior del gabinete de la secadora Para limpiar el tambor de la secadoraEn el ducto de escape Cuidado durante las vacaciones o falta de usoSin calor Solucion DE ProblemasPF corte de corriente, revise Io siguiente La secadora muestra mensajes codificadosIntente Io siguiente Cbdigos de servicio tcnico variables F1, F2, F20, etcPelusa en la ropa El tiempo del ciclo es demasiado cortoRopa arrugada Se esta usando la secadora por primera vez? OloresW10164636A Your Home