DELAY BUTTON
The | button will display four different setup screens. |
The screens will display in the following order:
Load On Delay - amount of time before fill auger starts once fill switch has been activated see
Out of Grain Timer - amount of time fill auger will run until fill switch has been activated
Fan Sequencing Delay - minimum amount of time between each fan startup
Unload Cleanout Delay - amount of time unload continues to run once meter rolls have stopped
SCREENS BUTTON
Press the | button and the display will then show a menu selection screen. |
This allows you to select between 3 different choices.
∙Out of Grain Time - allows you to view or change the Out of Grain Timer, or view how long it took for your dryer to fill.
∙View Grain Temps - allows you to view your grain temperatures on different modules (if so equipped).
∙Meter Roll SP Avg - shows you the percentage of time that the speed of the meter rolls system has spent on HI or Low speed.
Press the | buttons to move the pointer and allow you to select any of the three choices and |
then press the | button to jump to the next menu selection. |
Out of Grain Time
Press the | button and move the pointer to change your selection or just press the |
button on the Out of Grain Time selection gives you an additional 3 choices relating to your Out of Grain Timer.
∙Set Out of Grain - will allow you to change your Out of Grain Timer settings
∙Out of Grain Tmr - view the Out of Grain timer
∙Last Load Time - displays the amount of time it took for the fill paddle switch to become activated or the dryer filled.
Pressing the | button again on the Set Out of Grain allows you to adjust the time it takes for your dryer |
to run whenthe load paddle switch has not been activated. If this timer expires, your dryer will shut down giving you a out of grain warning. If you have a slow fill auger system, you would probably want to set this setting to a high value.
22 |
|