ately start, and the load auger switch will light up. If additional loading equipment is wired to the dryer it will also start immediately.
6.When the dryer is full of grain the top auger will stop automatically, and any auxiliary loading equipment wired to the dryer will also stop.
CONTINUOUS FLOW DRYING MODE
Full Heat-Continuous Flow Operation
1. | Turn the CONTORL POWER switch to on. |
|
2. | After the date and time appear on screen, press the | button. |
3.Turn the DRYING MODE switch to CONT. FLOW.
4.Make sure the UNLOAD switch is OFF.
5.Make sure the MOISTURE CONTROL switch is OFF.
6.Open the main fuel supply valve on the tank if using LP gas, or open the fuel supply line if using natural gas. Turn on the Maxon electric shut off valve, if so equipped, or open the manual shut off valve to allow fuel flow to the dryer.
7.Push the DRYER POWER START switch.
8.The dryer should already be filled with grain. Turn the LOAD AUGER switch to the AUTO position. In both the auto and manual positions, the dryer grain level switch will automatically keep the dryer full of grain. In the auto position the dryer will shut down after a preset time period using the out of grain timer.
9.Look in the Drying Charts section in the back of this manual for the FULL HEAT chart settings that corre- spond to your model of dryer. You will see the settings for (Initial Moisture) (Moisture Removed) (Approx. Dry Time) (1 Speed) (2 Speed Low) (2 Speed High) pick the line that has your initial starting moisture. These are the settings we will be referring to during this start up procedure.
10.Turn each FAN switch to ON. The fan will start, and the switch will light up when air pressure is detected.
11.Start each burner by turning the HEATER switch to ON. After purging for approximately 10 seconds the burner will fire, and the heater switch will light up. This indicates that the flame sensing circuit is sensing burner flame. For information concerning burner adjustment see the Dryer pre start checks section of this manual.
42 |
|