On this screen you can disable a fan and heater out of the Network loop. This would be used if you have a fan/ heater computer that is malfunctioning and rather than preventing you from using the dryer at all, you can just ignore it. So you can continue to use your dryer until you can have the dryer serviced. To change the fan/heater to
an inactive state, press the | buttons to toggle between active or inactive. Then press the |
button to accept your changes.
IMPORTANT NOTE! It is possible to change all your fan and heaters to an inactive state which would cause your dryer to be unable to dry grain.
The display screen will then advance to the next fan and heater on your dryer. You can easily configure your dryer to use both On/Off burners and Hi/Lo burners at the same time. This depends on your particular drying situation.
Possible reasons for using On/Off burner:
∙Low drying temperatures needed (ie. drying popcorn, rice, soybeans)
∙Very warm outside ambient temperatures
∙Drying grain that already has low moisture content requiring only 1 to 5 point moisture removal
∙May help prevent Vapor High Limit shutdowns
Possible reasons for using Hi/Lo burner:
∙Higher drying temperatures needed (ie. Hard to dry varieties of corn)
∙Colder outside ambient temperatures
∙High moisture content grain requiring
SET TIME & DATE
Use this screen to set the computers time and date. The time and date is preset at the factory but because of
different time zones you may find the need to change it. Just press the | button to advance to the | |
number on the line that needs to be changed or you can use the | button to back up to the previous | |
number on the line. Use the | to change the number directly above the flashing cursor. Once | |
you are satisfied with your changes press the | button to accept them. | |
74 |
|