TOPCOM Digital Baby Scale 2010
3Description
1 | 2 | 3 | 4 |
1.LCD display
2.MEMORY - button
3.ON/OFF - TARA Button
4.MODE - Button
4Simple operation
•Press the ON/OFF - TARA - button (3). The LCD display will show all segments for 2 seconds before entering weight mode.
•Press the MODE - button (4) to select ‘Kilogram (kg)’ or ‘Pound (lb)’
•Gently place the baby on the pan.
•The babies weight (maximum 20Kg) flashes on the display after a few seconds.
•If the baby remain lying on the pan after its weight is shown, the value will continue to flash for 5 minutes and then turn off automatically.
If you use a towl to lay the baby on, it should be placed on the pan before switching on. If you forgot to do so, press the ON/OFF - TARA button to eliminate the weight of the towl immediatelly after you have layed down the towl.
If you remove the towl, the scale will display a negative reading.
•Press and hold the ON/OFF - TARA - button (3) for a few seconds to turn the scale Off or it will turn off automatically in idle mode after 60 seconds.
5Memory
You can store the last result in the memory for later review.
•When the weight flashes on the display, press the MEMORY - button (2). ‘SET’ will be briefly
displayed.
To recall the weight:
•While the scale is in "0.00" situation, press the MEMORY - button (2).
•The stored weighing value saved in the memory and the ‘MEM’ icon is displayed.
•Press the MEMORY - button (2) again to leave the memory function.
6Error messages
Lo | Low power - Replace the batteries |
Err | Error during initialisation or measurement. Turn the scale off and on again and make |
| a new measurement. |
O_ld | Overload. The weight of the baby is over 20kg. |
4