Topcom 3300 user manual Specifications, Headset use, Sending Call Tones, Flashlight

ENGLISH

5.8. Using rechargeable batteries

IMPORTANT: Do not charge this unit using an AC/DC ADAPTER with regular “AAA” alkaline batteries installed. Only use the optional AC/DC ADAPTER with “AAA” rechargeable batteries (not included).

To use the PMR with an AC/DC ADAPTER and rechargeable batteries do the following:

1.Insert four (4) “AAA” rechargeable batteries (not included).

2.Plug the 7,5 V DC / 200 mA ADAPTER (not included) into the EAR/MIC/ CHARGER JACK on the top of the unit and turn it ON by pressing the POWER button.

NOTE: The unit cannot transmit calls while the batteries are being charged. It takes approximately 8 to 10 hours to fully charge the batteries.

5.9. Headset use

You can operate the PMR using a headset (not included).Plug the headset into the EAR/MIC jack (5).

5.10. Sending Call Tones

You can use Call Tones to alert the other user to identify yourself. You can also use Call Tones to signal the beginning or the end of a transmission.

1.Press and release the CALL button. The CALL TONE continues for 3 seconds.

2.Your CALL TONES will transmit to nearby receivers set to the same channel.

5.11. Flashlight

Press and hold the Flashlight button to activate the light.

6. SPECIFICATIONS

Channels

CTCSS Sub-channel

Output Power (TX)

Range

8 Channels

38 for each Channel

Output Power :0.5W (Maximum) Up to 3 Km (open field)

Topcom Twintalker 3300 7