IN CASE OF DIFFICULTY
Line Lights Remain On When No Line is Connected
•Make sure the system is programmed for that line to be absent. (See “Set Line Usage for Each Line” in SET UP SYSTEM FEATURES.)
•Make sure that your Line Groups are programmed properly. (See “Assign the Line Group for this Phone” in SET UP SYSTEM FEATURES.)
•Disconnect all other devices (fax, modem, credit card reader, etc.) from any lines connected to your 964 phone. These devices can interfere with the system’s data links.
•Make sure the total length of telephone wiring used in your 964 system is less than 600 feet. If the wiring is longer, you may need to use a special filter device. Call 1 800
Tone Signals Do Not Activate a Remote Device
•Tone signaling does not work during conference calls.
•The phone generates tones of fixed duration, which may not be long enough to activate some devices such as answering machines.
Operation During a Power Failure
Only Line 1 will operate during a power failure if a charged battery has been installed. You will be able to dial and answer calls, but no other features will work until power is restored.
No Caller ID Information While on a Call
•You must subscribe to combined Caller ID with Call Waiting as a single service to see Call Waiting information.
•Make sure the TEL SET and TEL LINE cords are not reversed.
Display Screen is Blank
Make sure the power cord is connected to both the phone and an electrical outlet not controlled by a wall switch.
Messages are Incomplete
If message length is programmed to one minute, messages longer than this will be cut off. See “Program Message Length” in SET UP SYSTEM FEATURES to change message length to unlimited.
IN CASE OF DIFFICULTY
System Does Not Answer After Correct Number of Rings
•See “Program Ring Time” in SET UP SYSTEM FEATURES to change how long the phone should ring before the system answers a call.
•
•If a fax machine shares a line with the answering system turned on, the Ring Time must be programmed to allow the fax machine to answer calls first. (See “Receiving a Fax When the Answering System Is On” in
ANSWERING SYSTEM
System Will Not Record Messages
When memory is full, saved messages must be deleted before new messages can be recorded.
System Does Not Respond to Remote Commands
•Make sure you are calling from a touch tone phone. When you dial a number, you should hear tones. If you hear clicks instead, the phone is not a touch tone telephone.
•There may be noise or interference on the phone line you are using. Press dial buttons firmly.
•You might be calling from a phone that sends tones too short for the 964 to detect.
No Caller ID Information Received
Caller ID information is transmitted by the telephone company between the first and second rings. Allow your phone to ring at least twice to receive Caller ID information.
NEW CALLS Light Flashes
•Make sure you have reviewed all messages on all lines.
•It may be a false indicator from the Central Office. To clear, see “Reset COVM Indicator” in CALLER ID OPERATION.
66 | 67 |