OPERATION
Compressor Operation
You do not have to use the maximum operating pressure at all times as the pneumatic tool being used often requires less pressure. Here are general guidelines for setting pressure.
1, With air compressor connected to proper power and turned ON, attach desired air tool or accessory to either LINE OUT 1 or LINE OUT 2 quick connect fittings. Use recommended air hose and quick connect fittings.
2.Activate air tool and turn PRESSURE CONTROL knob clockwise to increase outlet pressure.
WARNING
Exceeding pressure rating of attachments or inflatables can cause severe injury and/or property damage.
•DO NOT adjust pressure greater than maximum rating of attachments or inflatables.
3.Observe REGULATED PRESSURE GAUGE and adjust pressure to recommended setting of accessory tool.
NOTE:You must adjust regulated air pressure while tool is operating or activated.
4.Up to two tools or accessories may be connected to the air compressor at the same time. Each will receive air at the same regulated pressure.
5.Always operate this unit on a level surface to avoid lubrication problems.
Observe these safety precautions when operating air compressor:
WARNING
Compressor can start any time when plugged in.
•STAY CLEAR
•Disconnect from power source and drain pressure from tank when not in use or before servicing.
WARNING
Compressed air stream from hose or tank drain can cause soft tissue damage to exposed skin and can propel objects leading to severe injury
and / or property damage.
•DO NOT direct air stream at self or others.
•Always wear ANSI Z87.1 approved safety glasses with side shields.
WARNING
Compressed air is not breathable and can cause bodily injury.
Some paints or solvents may be harmful if inhaled or ingested, causing severe nausea, fainting or poisoning.
•DO NOT use compressed air for breathing.
•Always use NIOSH respirator approved for your application when spraying.
•Read all instructions with respirator so you are certain it will provide necessary protection against inhaling harmful vapors.
WARNING
Operating air compressor and tubing are HOT and can cause burns.
•DO NOT touch compressor or tubing.
•Allow compressor to cool before servicing.
WARNING
Contact with compressor or its cord can cause electric shock or burn.
Compressor must be grounded.
•DO NOT use grounding adapters. Inspect cord before each use.
•DO NOT operate with protective covers / guards removed or damaged.
•DO NOT operate in wet conditions. Store indoors.
•Disconnect from power source and drain pressure from tank when not in use or before servicing.
10