Briggs & Stratton 074001 manuel dutilisation Operation, Add Oil, Break-In Procedure, Shown in Open

OPERATION

Add Oil

1.Place the compressor on a flat, level surface.

2.Remove and discard the shipping cap. Using an oil funnel, slowly fill pump with oil to notch on dipstick (See Figure 1).

Figure 1 - Oil Fill Information

Inset of

Dipstick

Oil Fill

Location

MAXIMUM

Oil Level

PROPER

Oil Level

Drain Plug

3.Insert the dipstick. and check oil level. Oil level should be at the notch in the dipstick. Replace dipstick.

CAUTION

Serious damage may result if operating the unit with insufficient oil. Check oil level daily or with each use.

•Damage to equipment resulting from failure to follow this instruction will void warranty.

Break-In Procedure

Before first use of this equipment, the system must undergo a break-in operation, as described in this section.

CAUTION

Serious damage may result if the described break-in instructions are not closely followed.

•This procedure is required before air compressor is put into service and when check valve or a complete compressor pump has been replaced.

OPERATION

1.Make sure ON - OFF switch is in OFF position (see Figure 2).

Figure 2 - Pressure Switch with ON/AUTO - OFF Switch

ON - OFF Switch shown in OFF position

2.Plug power cord into grounded 120 Volt AC outlet (see Grounding Instructions on page 8).

3.Open both drain valves (rotate fully counterclockwise) to prevent air pressure build-up in air tank during break-in period (see Figure 3).

Figure 3 - Drain Valves in OPEN Position

Drain Valves

shown in OPEN

position

NOTE:Always drain air tank over a washable surface or in a suitable container to prevent damaging or staining surfaces.

4.Pull ON - OFF switch to ON position. Compressor will start.

NOTE: If you hear leaking air, pull quick connect coupler(s) back until it clicks to reset coupler valve.

5.Run compressor for 15 minutes. Make sure both drain valves remain open.

6.After 15 minutes, close both drain valves (rotate fully clockwise). Air tank will fill to “cut-out” pressure and compressor will stop.

NOTE: Check oil level in compressor after break-in.

The compressor has completed the break-In procedure and is ready for normal use.

7