Skil 3310 manual Push Stick and Push Block, Auxiliary Fence, Workpiece

SM 2610008289 02-10:3310 Table Saw 2/2/10 8:38 AM Page 56

Push Stick and Push Block

Make the Push Stick 1 using a piece of 1 x 2 as shown (Fig. 35).

FIG. 35

Make the Push Block 2 using pieces of 3/8" plywood 3 and 3/4" hardwood 4 (Fig. 36).

The small piece of wood, 3/8" x 3/8" x 2-1/2", should be GLUED to the plywood … DO NOT USE NAILS. This is to prevent dulling the sawblade in the event you mistakenly cut into the Push Block.

Position the handle in the center of the plywood and fasten together with glue and woodscrews.

Auxiliary Fence

Make one using pieces of 3/8" plywood 3 and 3/4" hardwood 4. Fasten together with glue and woodscrews (Fig. 37).

NOTE: Since the Push Block 2 is used with the Auxiliary Fence 5, the 4-3/4" dimensions must be held identical on both the pieces.

1-1/2"

1/4" 1/4"

3/4"

		15"	45° NOTCH
1/4"
	WORKPIECE		ENCOCHE À
	END		45°
	EXTRÉMITÉ		MUESCA DE
	CONTACT AVEC		45°
	L’OUVRAGE
	EXTREMO DE
	LA PIEZA DE
	TRABAJO
		FIG. 36

1

		12"	4
4-3/4"	5"
3/8"	12"		2
2-1/2"	2-1/2"
5-1/8"
	3/8"	3/8"	3
THESE EDGES
MUST BE PARALLEL

CES BORDS DOIVENT

ÊTRE PARALLÈLES

ESTOS BORDES DEBEN

SER PARALELOS

	FIG. 37
	3
	4
		1-3/4"
	4-3/4"	5
THIS FACE AND	19"
THIS EDGE MUST		5-1/2"
BE PARALLEL
CETTE FACE ET CE
BORD DOIVENT ÊTRE
PARALLÈLES
ESTA CARA Y ESTE
BORDE DEBEN SER
PARALELOS

NOTE: All dimensions in inches.

REMARQUE : Toutes les dimensions sont en pouces.

NOTA: Todas las dimensiones están en pulgadas.

56.