To control the
Do not use the digital clutch when tightening screws with a low tighten- ing torque into materials, such as thin plastic.
Example application not to be used;
When tightening screws into lightweight steel sheet which thickness is 0.8 mm or less.
When tightening screws into soft surface materials, such as interior finishing materials.
One-shot impact function : C
→Set the
The driver automatically rotates approx- imately half round and stops each time the trigger switch is depressed. (For bolts, it stops after approximately 5 impacts.)
Within 1 sec. after the trigger switch is released once, if it is depressed again, the
Indication lights on the control panel
The indication lights will go off in the following cases.
•The driver is not operated for 5 min.
•When the battery is replaced. Depressing the trigger switch again, then indication lights go on in the previous condition.
Main recommended applications and setting guidelines.(see p.13.)
Be sure to set the impact power mode and digital clutch to match the material and screws being used for the application.
Adjust the settings from low to high while checking them to settle on a final setting for impact power mode select and for digital clutch setting.
When driving screws into wood, use the screws of less than 90 mm long and avoid knots of wood materials.
∗
Impact Power Mode Select
Selecting the impact power among 3 modes (Hard, Medium, Soft).
Impact power mode button
Press the impact power mode button to set it. The mode changes to hard, medium, or soft each time the button is pressed. To use automatic mode shifting, press the button for a period (0.6 sec. or more). It is recommended that the impact power mode select be used together with the digital clutch setting and
The driver is preset to “hard” impact mode setting when shipped from the manufacturer.
Recommended work guideline table
When maximum power is required in each impact mode, set the clutch to the “F” mode.
Impact | Recommended Application |
Power mode | |
Display |
|
H | For hard impact power mode. |
Fastening long wood screws. | |
Approx. | Tightening bolts when install- |
ing devices, etc. | |
2,800R.P.M.(Max.) |
|
M | For medium impact power mode. |
Fastening small diameter | |
| screws into hard materials. |
Approx. | Driving machine screws when |
2,500R.P.M.(Max.) | installing devices. |
|
|
S | For soft impact power mode. |
Installing gypsum board. | |
| Installing soft metal window |
Approx. | flame. |
2,000R.P.M.(Max.) | Installing interior finishings. |
|
|
One-Shot Impact Function
This function helps adjust the screw head flush to the material surface.
The driver rotates half round∗ and auto- matically stops each time the trigger switch is depressed while tightening a screw. The driver will give impact about 5 times and automatically stop while tightening a bolt even though the trigger switch is depressed. The
- 8 -