When using your air-condi- tioner with multi-system
With a multi system air conditioner, mul- tiple indoor units can be connected to one outdoor unit. When the setting mode differs among indoor unit(s), the indoor unit(s) operated later may not work.
•When the indoor unit(s) is/are operating in HEAT mode, the remaining unit(s) can not operate in COOL or DRY mode.
•When the indoor unit(s) is/are operating in COOL or DRY mode, the remaining unit(s) can not operate in HEAT mode.
When the mode of the indoor unit(s) later op- erated is/are different from those which is/are in operation, after a few seconds, a long BEEP will be emitted and the temperature indicator
on the indicator panel will indicate” ” and the OPERATION lamp and TIMER lamp will blink alternately. This shows that the later op- erated unit(s) is/are not working. In such case, change the mode to the same mode which the other indoor unit(s) is/are operating in.
TIPS ABOUT AUTO MODE
In the AUTO mode, the temperature setting and mode are automatically selected accord- ing to the room temperature and outdoor temperature when the unit is turned on.
•During operation, if the outdoor tempera- ture changes, the temperature settings will automatically slide as shown in the chart.
Modes and Temperature Settings
The figures in ( ) are temperature settings
•When using your
ADJUSTING THE AIR FLOW DIRECTION
VERTICAL AIR FLOW DIRECTION
ENGLISH
1 Press the SWING button on the remote control once.
•The vertical adjustment louvres will swing continuously.
2 Press the SWING button again when the vertical adjustment louvres are at the desired position.
1
2
NOTE:
•The adjusted position will be memorized and will be automatically set to the same position when operated the next time.
Adjustment range
COOL and DRY modes | HEAT mode |
HORIZONTAL AIR FLOW DIRECTION
Hold the horizontal adjustment louvre as shown in the diagram and adjust the air flow direction.
CAUTION:
Never attempt to adjust the vertical adjustment lou- vres manually.
•Manual adjustment of the vertical adjustment lou- vre can cause the unit to malfunction when the remote control is used for adjustment.
•When the vertical adjustment louvre is positioned at the lowest position in the COOL or DRY mode for an extended period of time, condensation may result.
Do not adjust the horizontal adjustment louvre to the ex- treme left or right in the COOL mode with the fan speed set to “SOFT ( 
)” for an extended period of time.
Condensation may form on the louvres.