ICP-CC404 Installation Guide 7.0 Remote Arming by Telephone
6.3.7Turning Day Alarm On and Off
Pressing and holding [4] turns Day Alarm on or off. If you want the STAY indicator to indicate the status of Day Alarm operation (enabled or disabled), select Option 8 in Location 428 (refer to Section 18.5 Consumer Options 1 on page 75). When this option is selected, the STAY indicator flashes once every 3 sec when Day Alarm is active.
To turn Day Alarm on:
Press and hold [4] until three beeps sound.
To turn Day Alarm off:
Press and hold [4] until two beeps sound.
6.3.8Fault Analysis Mode
There are a number of system faults that can be detected by the control panel. When any of these faults are present, the FAULT indicator flashes and the codepad beeps once per minute. Refer to Section
4.12Fault Analysis Mode on page 22 for more information on each fault type.
To determine the type of fault:
Press and hold [5] until two beeps sound.
The STAY, AWAY, and FAULT indicators flash. One or more zone indicators (1 to 8) light to indicate the type of fault that occurred. Refer to Table 14 on page 22.
To Exit from Fault Analysis Mode:
Press [AWAY].
The STAY and AWAY indicators turn off and the system returns to the disarmed state.
6.3.9Initiate a Modem Call
Pressing and holding [6] until two beeps sound forces the control panel to dial the callback telephone number programmed in Locations 159 to 174 (refer to Section 11.9 Call Back Telephone Number on page 49) in an attempt to connect to the installer’s remote computer.
The remote computer must be running the CC816 Alarm Link Software and must be set to Waiting for an Incoming Call. If no callback telephone number is programmed, pressing and holding [6] has no effect.
6.3.10 Reset Latching Outputs
Pressing and holding [7] until two beeps sound resets any output that is programmed to remain on after it is activated.
The output must be programmed with a latching polarity. Refer to Section 16.3 Output Polarity on page 68 for more information.
6.3.11 Codepad Buzzer Tone Change
Pressing and holding [8] down continuously changes the tone of the buzzer in the remote codepad. There are fifty different tones from 1500 Hz to 5000 Hz. In an installation with multiple codepads, you can set a different tone for each codepad.
To change the buzzer tone:
1.Press and hold [8] continuously.
The tone of the buzzer increases in pitch.
2.Release [8] button when you hear the desired tone.
Every time power is removed from the system, you must reset each codepad to its individual tone using this function.
6.3.12 Send Test Report
Pressing and holding [9] until two beeps sound sends a Test Report (Contact ID Event Code 602) to test the dialing and reporting capabilities of the system without activating the sirens.
7.0Remote Arming by
Telephone
You can arm your system from any remote location by telephone. For security reasons, you cannot disarm the system using this method. A
To remotely arm your system by telephone:
1.Call the telephone number to which your control panel is connected.
When the control panel answers the incoming call, a short jingle sounds.
If you hear a number of unusual tones when the control panel answers the incoming call, the system is programmed for remote programming functions. Wait for a pause in the tones and follow Step 2 to arm the system remotely.
2.Hold the phone controller to the mouthpiece of the telephone and press and hold the button on the side of the unit for 3 sec.
You can also press and hold [*] on the
Two beeps sound to indicate that the system is armed in AWAY Mode.
3.Hang up the telephone. The system remains armed.
38 | Bosch Security Systems, Inc. 12/08 |