Use the meat grinder to process meat, poultry and fish. Use the inclusive attachments to shape sausages and kebbe.
before using your Kenwood appliance
●Read these instructions carefully and retain for future reference.
●Remove all packaging and any labels.
safety
●Always ensure bones and rind etc are removed from the meat before mincing.
●When mincing nuts only feed a few down at a time and allow the scroll to pick them up before adding any more.
●Always unplug:
●before fitting or removing parts
●after use
●before cleaning.
●Always use the pusher supplied. Never put your fingers or utensils in the feed tube.
●Warning - the cutting blade is sharp, handle with care both in use and cleaning.
●Ensure the attachment is secured in position before switching on.
●To avoid electric shocks, never let the power unit, cord or plug get wet.
●Never use a damaged mincer. Get it checked or repaired: see ‘Service’.
●Never use an unauthorised attachment.
●Never let the cord hang down where a child could grab it.
●This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
●Children should be supervised to ensure that they do not play with the appliance.
●Only use the appliance for its intended domestic use. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions.
before plugging in
●Make sure your electricity supply is the same as the one shown on the underside of your machine.
●This appliance conforms to EC directive 2004/108/EC on Electromagnetic Compatibility and EC regulation no. 1935/2004 of 27/10/2004 on materials intended for contact with food.
before using for the first time
1Wash the parts see ‘care and cleaning’
mincer
apower unit
battachment outlet c locking screw
d on/off switch
ereverse switch f spanner
g ring nut
h mincer screens: fine, medium, coarse
icutter j scroll
k mincer body l tray
m pusher
n pusher lid o dish/cover
to assemble
1Fit the scroll inside the mincer body.
2 Fit the cutter – cutting side
outermost . Ensure it’s seated properly – otherwise you could damage your mincer.
3 Fit a mincer screen . Put the notch over the pin.
4