Vulcan-Hart SG4D ML-114875, SG6D ML-114877 Troubleshooting Guide, Problem, Cause, Correction

TROUBLESHOOTING GUIDE

PROBLEM		CAUSE		CORRECTION
Uneven browning or overcooking	1. Power level control setting too		1.	Reduce	power	level control
at edges of pans.		high.		setting	(see	Cooking
				Guidelines in this manual).
	2. Too many racks used.
			2.	Reduce number of racks used.
			1.	Level oven, on the racks, from
Product pulling to edge of pan or	1.	Oven out of level.		side to side and front to back.
spilling.				The rack should check dead
				level side to side and from level
				to 1/8" (3 mm) low at the front
				from front to back.
			2.	Keep pans used for baking
	2.	Sheet pans warped.		batter separate from general
				purpose pans. If any pan
				shows a tendency to warp,
				remove it from the baking
				group.
Product overbrowning before	Power level control setting too high.		Reduce power level control setting
done or shrinking and over-			(see Cooking Guidelines in this
browning at edges.			manual).
Excessive shrinkage.	1.	Failure to maintain water in	1.	Place pan of water (approx.
		oven.		12"x20"x1" (305x508x25 mm)
				in bottom of oven.
	2.	Roasting temperature too high.	2.	Reduce temperature.
No Ignition Light remains lit for			1.	Turn oven off for 5 minutes
more than 20 seconds after 3				before attempting to relight.
trials (Models SG4D and SG6D),
(Models SG4C and SG6C).			2.	Check gas supply valves to be
				sure they are open.
			3.	Check electrical power source
				and connections.

FORM 35624 REV.A (08-04) — 28 —

(Formerly F-31024 & F-33220)