Shindaiwa EB802RT Manufacturers Warranty Coverage, OWNER’S Warranty Responsibilities, Limitations

Page 19

The following statement only applies to United States and its territories

Shindaiwa Corporation

Federal Emission Design And Defect Limited Warranty Utility And Lawn And Garden Engines

Shindaiwa Corporation warrants to the initial purchaser and each subsequent owner, that this utility equipment engine (herein engine) is designed, built and equipped to conform at the time of initial sale, to all applicable regulations of the U.S. Environmental Protection Agency (EPA), and that the engine is free of defects in materials and workmanship that would cause this engine to fail to conform with EPA regulations during its warranty period. This emission warranty is applicable in all States, except the State of California.

For parts listed under PARTS COVERED, the dealer authorized by Shindaiwa Corporation will, at no cost to you, make the necessary diagnosis, repair, or replacement of any defective emission-related component to ensure that the engine complies with applicable U.S. EPA regulations.

MANUFACTURERS WARRANTY COVERAGE

When sold within the U.S., this engine’s emission control system is warranted for a period of two (2) years from the date this product is first delivered to the original retail purchaser.

OWNER’S WARRANTY RESPONSIBILITIES

As the engine owner, you are responsible for the performance of the required maintenance listed in your owner’s manual. Shindaiwa Corporation recommends that you retain all receipts covering maintenance on your engine, but Shindaiwa Corporation cannot deny a warranty claim solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance.

As the engine owner, you should however be aware that Shindaiwa Corporation may deny your warranty coverage if your engine or a part has failed due to abuse, neglect, improper maintenance or unapproved modifications.

You are responsible for presenting your engine to the nearest dealer authorized by Shindaiwa Corporation when a problem exists.

If your Shindaiwa Dealer is unable to answer questions regarding your warranty rights and responsibilities, you should then contact your Shindaiwa Distributor.

For the name and telephone number of the Shindaiwa Distributor in your area, please call Shindaiwa Inc. at (503) 692-3070 between the hours of 8:00 AM and 5:00 PM Pacific Standard Time.

PARTS COVERED

Listed below are the parts covered by the Federal Emission Design and Defect Warranty. Some parts listed below may require scheduled maintenance and are warranted up to the first scheduled replacement of that part. The warranted parts include:

1.Carburetor Internal Components

•Valve Assembly-throttle, Jet, Metering Diaphragm

2.Ignition System Components

•Ignition Coil

•Flywheel Rotor

The emission control system for your particular Shindaiwa engine may also include certain related hoses and connectors.

MAINTENANCE AND REPAIR REQUIREMENTS

You are responsible for the proper use and maintenance of the engine. You should keep all receipts and maintenance records covering the performance of regular maintenance in the event questions arise. These receipts and maintenance records should be transferred to each subsequent owner of the engine. Shindaiwa Corporation reserves the right to deny warranty coverage if the owner has not properly maintained the engine. Shindaiwa Corporation will not deny warranty repairs, however, solely because of the lack of repair, maintenance or failure to keep maintenance records.

MAINTENANCE, REPLACEMENT OR REPAIR OF EMISSION CONTROL DEVICES AND SYSTEMS MAY BE PERFORMED BY ANY REPAIR ESTABLISHMENT OR INDIVIDUAL; HOWEVER, WARRANTY REPAIRS MUST BE PERFORMED BY A DEALER OR SERVICE CENTER AUTHORIZED BY SHINDAIWA CORPORATION THE USE OF PARTS THAT ARE NOT EQUIVALENT IN PERFORMANCE AND DURABILITY TO AUTHORIZED PARTS MAY IMPAIR THE EFFECTIVENESS OF THE EMISSION CONTROL SYSTEM AND MAY HAVE A BEARING ON THE OUTCOME OF A WARRANTY CLAIM.

If other than the parts authorized by Shindaiwa Corporation are used for maintenance replacements or for the repair of components affecting emission control, you should assure yourself that such parts are warranted by their manufacturer to be equivalent to the parts authorized by Shindaiwa Corporation in their performance and durability.

OBTAINING WARRANTY SERVICE

All repairs qualifying under this limited warranty must be performed by a dealer authorized by Shindaiwa Corporation

If any emission-related part is found defective during the warranty period, it is your responsibility to present the product to an authorized Shindaiwa dealer. Bring your sales receipts showing the date of purchase for this engine. The dealer authorized by Shindaiwa Corporation will perform the necessary repairs or adjustments within a reasonable amount of time and furnish you with a copy of the repair order. All parts and accessories replaced under this warranty become the property of Shindaiwa Corporation

To locate an authorized Shindaiwa dealer near you, contact your Shindaiwa Distributor. For the name and telephone number of the Shindaiwa Distributor in your area, please call Shindaiwa Inc. at (503) 692-3070 between the hours of 8:00 AM and 5:00 PM Pacific Standard

Time.

THIS WARRANTY IS ADMINISTERED BY

Shindaiwa Inc.

11975 S.W. Herman Rd. Tualatin OR. 97062 (503) 692-3070

LIMITATIONS

The Federal Emission Design and Defect Warranty shall not cover any of the following:

(a)conditions resulting from tampering, misuse, improper adjustment (unless they were made by the dealer or service center authorized by Shindaiwa Corporation during a warranty repair), alteration, accident, failure to use the recommended fuel and oil, or not performing required maintenance services,

(b)the replacement parts used for required maintenance services,

(c)consequential parts used for required maintenance services,

(d)diagnosis and inspection fees that do not result in eligible warranty service being performed, and

(e)any non-authorized replacement part, or malfunction of authorized parts due to use of non-authorized parts.

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents EB802 EB802RTIntroduction ContentsSafety Labels General Safety InstructionsBe Aware of the Working Environment Properly Equipped OperatorMeters EB802 Unit DescriptionPrior to Assembly AssemblyAssembling the Blower Assembling the RT Blower Fuel is Highly Flammable Mixing fuelFilling the fuel tank Examples of 501 mixing quantitiesRecoil starter can be damaged by abuse Starting procedureWhen The Engine Starts Starting the EngineStarting a Flooded Engine Adjusting Engine Idle SpeedStopping The Engine If The Engine Does Not StartCruise Function Setting Throttle LimiterAdjusting Throttle Limiter Throttle Control RTUsing The Blower Adjusting The HarnessOperating Tips Every 10 Hours MaintenanceDaily Maintenance Prior to each workday, perform the followingEvery 50 Hours Every 10/15 HoursMore frequently if reduced performance is noted Remove the Spark Arrester Hour MaintenanceLong Term Storage Remove the MufflerRemedy Troubleshooting GuideWhat To Check Possible CauseEngine is knocking Is the engine overheating?Engine speed is reduced Excessive vibration Poor accelerationEngine stops abruptly Engine difficult to shut offObtaining Warranty Service Manufacturers Warranty CoverageOWNER’S Warranty Responsibilities Maintenance and Repair RequirementsPage ¡ADVERTENCIA Soplador EB802 Soplador EB802RTNota Introducción Notas de Interés EspecialÍndice ¡PRECAUCIÓNManténgase alerta Instrucciones Generales de SeguridadEtiquetas de Seguridad Trabaje de manera seguraPreste Atención al Entorno de Trabajo Operador Adecuadamente EquipadoEspecificaciones Descripción de la Unidad¡Peligro con la turbina giratoria EnsamblajeAntes de proceder con el armado Armado del Soplador¡ADVERTENCIA! ¡Peligro con la turbina giratoria Armado del Soplador RTAdvertencia Mezcla de CombustibleLlenando el Tanque de Combustible PrecauciónProcedimiento de arranque Arranque del motor¡Peligro con el impulsor giratorio ¡Peligro con el polvo o los residuos despedidosSi el motor no arranca Arranque del motor continuaciónDetención del motor Ajuste de la marcha ralentí del motorLimitador del acelerador Configuración del limitador del aceleradorControl del acelerador Soplador RT Función CruiseUso del soplador Ajuste del arnésConsejos para operar Más frecuentemente en condiciones rigurosas MantenimientoMantenimiento Diario Cada 10 HorasMás frecuentemente si observa que cae el rendimiento Mantenimiento continuacionCada 10 a 15 Horas Cada 50 HorasRetire el silenciador Almacenamiento ProlongadoMantenimiento Cada 135 Horas Cada 135 horas de operación, retire y limpie el silenciadorRemedio Guía DiagnósticoQué revisar Posible causa¿Se sobrecalienta el motor? Guía Diagnóstico continuaciónEl motor golpea Excesiva vibración Deficiente aceleraciónEl motor se detiene abruptamente Difícil apagado del motorLimitaciones Esta Garantía ES Administrada PORCobertura DE LA Garantía DEL Fabricante Piezas CubiertasNotas Avertissement Souffleur EB802 Souffleur EB802 RTRemarque Introduction Mises en gardeTable des matières Mise EN GardeÉtiquettes de sécurité Mesures de sécurité généralesTenir compte de l’environnement de travail ’utilisateur bien équipéCaractéristiques techniques Description de l’appareilAvant l’assemblage AssemblageAssemblage du souffleur AssemblingIMPORTANTthe Unit Assemblage du souffleur RT Assemblage suiteRéduire les risques d’incendie Mélange de carburantRemplissage du réservoir à carburant Exemples de quantités de mélange de carburant àLorsque le moteur démarre Démarrage du moteurProcédure de démarrage Déposer le souffleur sur le solSi le moteur ne démarre pas Démarrage du moteur suiteArrêt du moteur Réglage du régime de ralenti du moteurRéglage du limiteur de régime moteur Réinstaller le bouchon du limiteur de régime moteurLimiteur de régime moteur RT Fonction de régulation « Cruise »Utilisation du souffleur Mise en place du harnaisConseils dultilisation Entretien quotidien EntretienAprès 10 heures Après 50 heures Entretien Suite Après 10 à 15 heuresPlus fréquemment en cas de baisse de la performance Enlever le para-étincelles Entretien Suite Après 135 heuresRemisage à long terme Enlever le silencieuxCause probable SolutionGuide de dépannage Points à contrôlerGuide de dépannage suite Points à contrôler Cause probable SolutionMoteur difficile à ar- rêter ’accessoire de coupeFaible accélération Le moteur s’arrête brusquementLA Présente Garantie EST Gérée PAR Étendue DE LA Garantie DU FabricantResponsabilités DU Propriétaire À L’ÉGARD DE LA Garantie Pièces Prises EN Charge
Top Page Image Contents