Shindaiwa 68242-94311, EB802RT manual Introduction, Contents

Page 2

Introduction

Attention Statements

The Shindaiwa blower has been designed and built to deliver superior performance and reliability without compromise to quality, comfort, safety, or durability.

The information contained in this manual describes units available at the time of production. While every attempt has been made to give you the very latest information about your Shindaiwa blower. There may be some differences between your blower and what is described here. Shindaiwa Inc. reserves the right to make changes in production without prior notice, and without obligation to make alterations to units previously manufactured.

IMPORTANT!

Before using this unit, consult local regulations concerning noise restrictions and hours of operation!

WARNING!

The engine exhaust from this unit contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm.

CAUTION!

This blower is equipped with a spark- arresting muffler! Never operate this unit without both the muffler and spark arrester installed and properly functioning!

Contents

PAGE

Attention Statements

2

General Safety Instructions

3

Unit Description

5

Specifications

5

Assembling the Blower

6

Mixing Fuel

8

Filling the Fuel Tank

8

Starting and Stopping the Blower

8

Adjusting Engine Idle Speed

9

Adjusting the Harness

10

Using the Blower

10

Maintenance

11

Storage

13

Troubleshooting Guide

14

Emission System Warranty

17

Throughout this manual are special “Attention Statements”.

WARNING!

A statement preceded by the triangular Attention Symbol and the word “WARNING” indicates a potentially hazardous situation which, if not avoided, COULD result in death or serious injury.

CAUTION!

A statement preceded by the word “CAUTION” contains information that should be acted upon to avoid damaging the unit.

IMPORTANT!

A statement preceded by the word “IMPORTANT” is one that possesses special significance.

NOTE:

A statement preceded by the word “NOTE” contains information that is handy to know and may make your job easier.

Read and follow this manual. Failure to do so could result in serious injury.

Wear eye and hearing protection at all times during the operation of this unit.

Keep hair and loose clothing clear of the air inlet.

This unit is intended for outdoor use only and should be used only in well ventilated areas.

WARNING! Surface can be hot. Always wear gloves when handling this unit.

IMPORTANT!

The operational procedures described in this manual are intended to help you get the most from this unit and also to protect you and others from harm. These procedures are general guidelines only, and are not intended to replace any safety rules/laws that may be in force in your area. If you have any questions regarding your blower, or if you do not understand something in this manual, your Shindaiwa dealer will be glad to assist you. For additional information, you may also contact Shindaiwa Inc. at the address printed on the back of this manual.

Image 2
Contents EB802RT EB802Contents IntroductionGeneral Safety Instructions Safety LabelsMeters Properly Equipped OperatorBe Aware of the Working Environment Unit Description EB802Assembling the Blower AssemblyPrior to Assembly Assembling the RT Blower Examples of 501 mixing quantities Mixing fuelFilling the fuel tank Fuel is Highly FlammableStarting the Engine Starting procedureWhen The Engine Starts Recoil starter can be damaged by abuseIf The Engine Does Not Start Adjusting Engine Idle SpeedStopping The Engine Starting a Flooded EngineThrottle Control RT Setting Throttle LimiterAdjusting Throttle Limiter Cruise FunctionOperating Tips Adjusting The HarnessUsing The Blower Prior to each workday, perform the following MaintenanceDaily Maintenance Every 10 HoursMore frequently if reduced performance is noted Every 10/15 HoursEvery 50 Hours Remove the Muffler Hour MaintenanceLong Term Storage Remove the Spark ArresterPossible Cause Troubleshooting GuideWhat To Check RemedyEngine speed is reduced Is the engine overheating?Engine is knocking Engine difficult to shut off Poor accelerationEngine stops abruptly Excessive vibrationMaintenance and Repair Requirements Manufacturers Warranty CoverageOWNER’S Warranty Responsibilities Obtaining Warranty ServicePage Soplador EB802 Soplador EB802RT ¡ADVERTENCIA¡PRECAUCIÓN Introducción Notas de Interés EspecialÍndice NotaTrabaje de manera segura Instrucciones Generales de SeguridadEtiquetas de Seguridad Manténgase alertaOperador Adecuadamente Equipado Preste Atención al Entorno de TrabajoDescripción de la Unidad EspecificacionesArmado del Soplador EnsamblajeAntes de proceder con el armado ¡Peligro con la turbina giratoriaArmado del Soplador RT ¡ADVERTENCIA! ¡Peligro con la turbina giratoriaPrecaución Mezcla de CombustibleLlenando el Tanque de Combustible Advertencia¡Peligro con el polvo o los residuos despedidos Arranque del motor¡Peligro con el impulsor giratorio Procedimiento de arranqueAjuste de la marcha ralentí del motor Arranque del motor continuaciónDetención del motor Si el motor no arrancaFunción Cruise Configuración del limitador del aceleradorControl del acelerador Soplador RT Limitador del aceleradorConsejos para operar Ajuste del arnésUso del soplador Cada 10 Horas MantenimientoMantenimiento Diario Más frecuentemente en condiciones rigurosasCada 50 Horas Mantenimiento continuacionCada 10 a 15 Horas Más frecuentemente si observa que cae el rendimientoCada 135 horas de operación, retire y limpie el silenciador Almacenamiento ProlongadoMantenimiento Cada 135 Horas Retire el silenciadorPosible causa Guía DiagnósticoQué revisar RemedioEl motor golpea Guía Diagnóstico continuación¿Se sobrecalienta el motor? Difícil apagado del motor Deficiente aceleraciónEl motor se detiene abruptamente Excesiva vibraciónPiezas Cubiertas Esta Garantía ES Administrada PORCobertura DE LA Garantía DEL Fabricante LimitacionesNotas Souffleur EB802 Souffleur EB802 RT AvertissementMise EN Garde Introduction Mises en gardeTable des matières RemarqueMesures de sécurité générales Étiquettes de sécurité’utilisateur bien équipé Tenir compte de l’environnement de travailDescription de l’appareil Caractéristiques techniquesAssemblage du souffleur AssemblingIMPORTANTthe Unit AssemblageAvant l’assemblage Assemblage suite Assemblage du souffleur RTExemples de quantités de mélange de carburant à Mélange de carburantRemplissage du réservoir à carburant Réduire les risques d’incendieDéposer le souffleur sur le sol Démarrage du moteurProcédure de démarrage Lorsque le moteur démarreRéglage du régime de ralenti du moteur Démarrage du moteur suiteArrêt du moteur Si le moteur ne démarre pasFonction de régulation « Cruise » Réinstaller le bouchon du limiteur de régime moteurLimiteur de régime moteur RT Réglage du limiteur de régime moteurConseils dultilisation Mise en place du harnaisUtilisation du souffleur Après 10 heures EntretienEntretien quotidien Plus fréquemment en cas de baisse de la performance Entretien Suite Après 10 à 15 heuresAprès 50 heures Enlever le silencieux Entretien Suite Après 135 heuresRemisage à long terme Enlever le para-étincellesPoints à contrôler SolutionGuide de dépannage Cause probablePoints à contrôler Cause probable Solution Guide de dépannage suiteLe moteur s’arrête brusquement ’accessoire de coupeFaible accélération Moteur difficile à ar- rêterPièces Prises EN Charge Étendue DE LA Garantie DU FabricantResponsabilités DU Propriétaire À L’ÉGARD DE LA Garantie LA Présente Garantie EST Gérée PAR