Galaxy GHDX2-2430S/R-24F4D Installation and Hardware Reference Manual
System Monitoring
3-4
remain intact after default restoration, configuration data such as LUN mapping
and performance preferences will be erased. Before using this button, make sure
you have a written record or a previously saved configuration profile (one of
firmware’s functionalities, “Save NVRAM”).
Please refer to Chapter 1 for the correct procedures of default restoration.
3.2.2 LAN Port LEDs
A shielded Ethernet cable is recommended for connecting the RJ-45 Ethernet
management port to a local network after you configure an IP address. This enables you
to manage your subsystem via LAN/WAN. Two (2) LEDs on the Ethernet port indicate
connection statuses. Please refer to Error! Reference source not found. for the LED
definitions.
Figure 3-2: LAN Port Indicators
Name Color Status
Link Green ON indicates the management port is connected to a
node or networking device.
Activity Green BLINKING indicates active transmission
Table 3-3: LAN Connector LED Definitions
3.2.3 LCD Keypad Panel
The LCD keypad panel comes with three (3) status-indicating LEDs, from top to bottom,
PWR, BUSY, and ATTEN. The definitions of these LEDs are shown in Table 3-5.