Chapter 16: Solving Problems

●

148

Failed Disk Drive Protected by a Hot Spare

When a logical drive is protected by a hot spare, if a disk drive in that 

logical drive fails the hot spare is automatically incorporated into the 

logical drive and takes over for the failed drive. 

For instance, when a disk drive fails in the RAID 5 logical drive shown 

in the example below, the logical drive is automatically rebuilt (its data 

is reconstructed) using the hot spare in place of the failed drive. You 

can’t access the logical drive until the rebuilding is complete.

Note: 

In the example above, the color of the hot spare changed from 

light-blue to dark-blue, showing that it is now part of a logical drive.

To recover from the failure:

1

Remove and replace the failed disk drive (following manufacturer’s 

instructions).

2

If copyback is not enabled—Remove the ‘hot spare’ designation from 

the original hot spare (the disk drive that was built into the logical 

drive). See 

page 93

 for instructions. Then, designate a new hot spare 

to protect the logical drives on that controller. 

If copyback is enabled—Data is automatically moved back to its 

original location once the controller detects that the failed drive has 

been replaced. No action is required. See 

Enabling Copyback on page 

98

 for more information.

...and logical drive is 

rebuilt with hot spare

Disk drive shows

Failed status...

...hot spare takes over...

Page 149
Image 149
Open full-size image