Note

The initiator and Target ID’s must be assigned before the address table can be configured.

Table 5-2

SCSI-to-Fibre Target:Channel Address

 

Mapping

 

 

 

 

 

 

SCSI BUS:TARGET:LUN

Fibre Channel

AL_PA

LUN

 

 

 

 

 

 

 

0:4:1

0x10

0

 

 

 

 

 

0:4:2

0x17

0

 

 

 

 

 

0:4:3

0x18

0

 

 

 

 

The Index Table is edited to represent the desired mapping, and saved to FLASH memory.

In addition to configuring the address mapping, SCSI-to-Fibre Channel mode requires that a SCSI interface on the FCR200 be configured to respond to specified SCSI IDs. This is done through the SCSI configuration menu. Target ID’s enabled for the FCR200 must be unique on the SCSI bus, with the exception that the initiator ID used on the FCR200 should also be used as a single target ID. For example, in SCSI-to-Fibre Channel mode, one of the targets must have the same ID as the FCR200.

SCSI Host to Fibre Channel Target Configuration

5-9

 

 

 

 

Page 71
Image 71
ADIC FCR 200 manual Scsi Host to Fibre Channel Target Configuration