ADS Technologies SBG1000 manual If necessary, seat an anchor in each hole

Overview Installation Troubleshooting Contact FAQ Specifications Glossary License

Configuration: Basic Gateway TCP/IP Wireless Print Server USB

6If necessary, seat an anchor in each hole.

Use M5 x 38 mm (#10-16 x 11/2 inch) screws with a flat underside and maximum screw head diameter of 10.5 mm to mount the SBG1000.

7Using a screwdriver, turn each screw until part of it protrudes from the wall, as shown:

• There must be .16 inches (4.0 mm) between the wall and the underside of the screw head.

• The maximum distance from the wall to the top of the screw head is 7.6 mm (.3 in).

.3 inches (7.6 mm) maximum

.4 inches (10.5 mm) maximum

.16 inches (4.0 mm)

8Place the SBG1000 so the keyholes on the back of the unit are aligned above the mounting screws. If you are using the built-in antennas, be sure you do not damage them.

9Slide the SBG1000 down until it stops against the top of the keyhole opening.

Home Print

X	27	SBG1000 User Guide
Exit