AT Commands: Serial
n=0 : Always assert DCD.
n=1 : Assert DCD when in a data mode (UDP, TCP, PPP, or SLIP) (Default).
n=2 : Assert DCD when the modem has network coverage.
&Dn
Set DTR mode.
n=0 : Ignore DTR, same effect as HW DTR always asserted (same as S211=1).
n=2 : Use hardware DTR (same as S211=0).
&Sn
Set DSR mode.
n=0 : Always assert DSR (Default).
n=1 : Assert DSR when in a data mode (UDP, TCP, PPP, or SLIP) .
n=2 : Assert DSR when the modem has network coverage.
&W
Writes all changed modem settings. If this command is not issued, any modified values will revert back to their previous values at modem reset.
Cannot be configured in Wireless Ace.
*PPPNOCARRIER=n
Provides a “No Carrier” message to a device connected to the serial port using PPP or CHAP when the cellular connection becomes unavailable.
n=0 : Disabled (Default).
n=1 : Enabled.
Raven X | 64 |
