Alcatel Carrier Internetworking Solutions 6600 manual 802.1X Commands

User Documentation Addendum vlan port-mac bandwidth

vlanHAPortTable

vlanHAPortVlanId vlanHAPortType vlanHAPortIfIndex

slMacToPortMacTable

vlanHAPortVlanId slMacToPortMacAddress

vlanTable vlanNumber

Chapter 42, “802.1X Commands”

On page 42-11 replace the Examples section for the show 802.1x command with the following:

-> show 802.1x 1/13

802.1x configuration for slot 1 port 13:

direction	=	both,
operational directions	=	both,
port-control	=	auto,
quiet-period (seconds)	=	60,
tx-period (seconds)	=	30,
supp-timeout (seconds)	=	30,
server-timeout (seconds)	=	30,
max-req	=	2,
re-authperiod (seconds)	=	3600,
reauthentication	=	no
Guest Vlan ID	=	20,
Supplicant polling retry count =		2

On page 42-12 the following two new field definitions should be added to the Output Definitions table for the show 802.1x command:

Guest VLAN ID	Indicates if a guest VLAN is configured for non-802.1x traffic received
	on the port. If so, a VLAN ID number appears in this field. Configured
	through the 802.1x guest-vlancommand This field does not appear on
	an OmniSwitch 6800.

Supplicant polling retry count

The number of times a device is polled for EAP frames to determine whether or not the device is an 802.1x client. Configured through the 802.1x supp-polling retry command. This field does not appear on an OmniSwitch 6800.

On page 42-13 the following MIB information should be added to the MIB Objects section for the show 802.1x command:

alaDot1xGuestVlanConfTable

alaDot1xGuestVlanNumber

alaDot1xSuppPollingCnt

The following three new commands should be included in this chapter:

Release 5.1.6.R02 User Guide Supplement June 2005 page 1-5