Alcatel Carrier Internetworking Solutions 6600 manual Ipv6 rip interface send-status

ipv6 rip interface send-status IPv6 Commands

ipv6 rip interface send-status

Configures IPv6 RIPng interface “Send” status. When this status is set to "enable", packets can be sent from this interface. When it is set to "disable", packets will not be sent from this interface.

ipv6 rip interface if_name send-status {enable disable}

Syntax Definitions

if name	IPv6 interface name.
enable disable	Interface “Send” status.
Defaults

parameterdefault

enable disable enable

Platforms Supported

OmniSwitch 6624, 6648, 7700, 7800, 8800

Usage Guidelines

RIPng must be loaded (ipv6 load rip) and enabled (ipv6 rip status)on the switch to send or receive pack- ets on the interface.

Example

-> ipv6 rip interface Test_Lab send-status enable

Release History

Release 5.1.6; command was introduced.

Related Commands

ipv6 load rip	Loads RIPng into memory.
ipv6 rip status	Enables/disables RIPng on the switch.

ipv6 rip interface recv-statusConfigures IPv6 RIPng interface “Receive” status.

MIB Objects

alaRipngInterfaceTable alaRipngInterfaceSendStatus

page 2-68 Release 5.1.6.R02 User Guide Supplement June 2005