IPv6 Commands | ipv6 rip interface |
|
|
|
|
ipv6 rip interface recv-status
Configures IPv6 RIPng interface “Receive” status. When this status is set to "enable", packets can be received on this interface. When it is set to "disable", packets will not be received on this interface.
ipv6 rip interface if_name recv-status {enable disable}
Syntax Definitions
if name | IPv6 interface name. |
enable disable | Interface “Receive” status. |
Defaults |
|
parameterdefault
enable disable | enable |
|
|
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
RIPng must be loaded (ipv6 load rip) and enabled (ipv6 rip status)on the switch to send or receive pack- ets on the interface.
Example
Release History
Release 5.1.6; command was introduced.
Related Commands
ipv6 load rip | Loads RIPng into memory. |
ipv6 rip status | Enables/disables RIPng on the switch. |
ipv6 rip interface
MIB Objects
alaRipngInterfaceTable alaRipngInterfaceRecvStatus
Release 5.1.6.R02 User Guide Supplement June 2005 | page |