102AMX Switch Series Installer/User Guide
Table F.1: Access Commands (Continued)
Command | Function | |
|
| |
| Enables this mode. The user station will then attempt to request the pod channel if it | |
enable rerequest pod | has been connected to a target and does not have the pod channel. The user station | |
will make one request approximately every 10 seconds. The request will only be | ||
| ||
| successful if the pod channel has been unused for the previous second. | |
|
| |
disable rerequest pod | Disables this mode. This cannot be done via the OSD if no switch is connected. | |
|
| |
| Turns On VCM Config access. | |
vcm sdb on | NOTE: Turning on VCM Config access must be done before using the commands | |
| below. The default setting is Off. | |
|
| |
vcm sdb off | Turns off VCM Config access. | |
|
| |
vcm cu | Tunes VCM (all three: red, green and blue) up 1 (setting is applied to current | |
connection only). | ||
| ||
|
| |
vcm cd | Tunes VCM down 1. | |
|
| |
vcm rcu | Tunes red VCM up 1. | |
|
| |
vcm rcd | Tunes red VCM down 1. | |
|
| |
vcm gcu | Tunes green VCM up 1. | |
|
| |
vcm gcd | Tunes green VCM down 1. | |
|
| |
vcm bcu | Tunes blue VCM up 1. | |
|
| |
vcm bcd | Tunes blue VCM down 1. | |
|
| |
vcm reset | Resets VCM. | |
|
| |
sk off | Turns skew off. | |
|
| |
sk apply | Applies skew. | |
|
|
