Avocent 590-222-501M manual Appendix F Command Functions, Table F.1 Access Commands Function

100AMX Switch Series Installer/User Guide

Appendix F: Command Functions

Table F.1: Access Commands

Command	Function
bl	Calls Bootloader.
print sys info	Prints system info and debug info to the serial port.
set def res 0	Sets default OSD resolution to low (640 x 480).
set def res 1	Sest default OSD resolution to high (1024 x 768).
do vcm	Performs VCM.
rev hw	Prints hardware revision to the serial port.
rev osd	Prints OSD revision to the serial port.
rev dl	Prints datalink revision to the serial port.
rev fw	Prints firmware revision to the serial port.
unit uid	Prints UID to the serial port.
sys info	Prints sys info to the serial port.
rm	Resets mouse.
rk	Resets keyboard.
rev fw	Displays firmware revision to the serial port.
rev dl	Displays datalink revision to the serial port.
	Configures the connected AMIQ module with matching “servername” to use the
	DDC table stored in the AMIQ module.
	Options are:
	•	ddctable ‘server234’ default (use the default ddc table)
ddctable ‘[servername]’	•	ddctable ‘server234’ nVidia (use the nVidia ddc table)
xxxxx	•	ddctable ‘server234’ disable (don’t use any ddc table)
	If configured correctly, you will see an OSD message stating the AMIQ module’s
	current configuration. To configure an AMIQ module, it must be available on the
	Target List.
fc ‘[userstationname]	Forces connection of [userstationname] to [servername].
‘‘[servername] ‘	Names are case sensitive. Use single quotes.

fd ‘[userstationname]	Forces disconnection on [userstationname] .
	Names are case sensitive. Use single quotes.