56AMX Switch Series Installer/User Guide
Locking user station settings
The Administrator may lock specific settings for each user station. Lockdown settings cannot be accessed by other users. See Administering security settings on page 45 for more information.
To enable lockdown settings:
1.Press Ctrl+Ctrl to launch the OSCAR interface.
2.Enable Force User Login, if necessary. See Administering security settings on page 45 for more information.
3.Click the Console tab, then click the down arrow button to display the Lockdown screen.
Figure 3.23: Lockdown Screen (Settings for the AMX 5130 User Station Shown)
NOTE: Available lockdown settings vary by user station model. Only the lockdown settings supported on the user station you are configuring will be displayed.
4.Select or deselect any of the following settings as needed:
•Select User Tab to prevent changes to the User tab.
•Select Console Tab to prevent changes to the console data.
•Select Private Switch Only to force Private mode connections to target devices.
•Select Serial Force Mode to allow forced connections through the serial port. Using force connect commands, you can force a user station to connect to a target device through the serial port. See Forcing a Connection to a Target Device on page 65 for more information.
•Select Auto User Login to force the user station to automatically log in a specific username each time there is a power cycle or hotplug. Enter the username and password in the fields provided to specify which user is automatically logged in.
Any user can disable auto user login by entering disable auto user login at the Command Line. See OSD Command Line Operations on page 61 and Disabling Auto User Login on page 63 for more information.
5.To save changes, click Apply. To exit the OSCAR interface, click Cancel or X.
