Avocent 590-222-501M manual Eeprom

Appendices 101

Table F.1: Access Commands (Continued)

Command	Function
	Enables persistent connection mode on a user station. Every time a connection is
enable persistent mode	made to a server, the UID of the server and the connection type are stored in
	EEPROM. If the connection is lost, these values are used to re-establish the
	connection.
disable persistent mode	Disables persistent connection mode. If a connection is lost, there will be no attempt
	to try to re-establish it.
show persistent mode	Shows the current persistent connection mode, and if enabled, shows the current
	stored UID and connection type settings.
vcm once (remove vcm	Enables VCM Once mode. This will cause VCM settings for the next connection to
	be stored in EEPROM and used in all subsequent connections. If this command is
blink)	executed when VCM is already in this mode, the VCM settings of the next
	connection established will replace the existing VCM settings in EEPROM.
vcm always	Disables VCM Once mode and returns the AMX 51xx switch to its normal VCM
	mode, where VCM is performed on every connection established.
vcm status	Shows the current VCM mode and displays the VCM settings currently stored in
	EEPROM.
disable auto user login	Clears the currently stored username and password that are stored if the Auto Login
	feature is enabled.
enable pod switch	Enables this mode. This cannot be done via the OSD if a switch is not connected.
mode
disable pod switch	Disables this mode. This cannot be done via the OSD if a switch is not connected.
mode
show pod switch mode	Shows the current status of this mode. This cannot be done via the OSD if a switch is
	not connected.
enable serial emulation	When serial emulation is enabled, the CPU’s serial port is disabled (AMX 5130
	switch user station only).
disable serial emulation	When serial emulation is disabled, the CPU’s serial port is enabled (AMX 5130
	switch user station only).
equalization tuning	Shows the Equalization Tuning OSD.
deskew tuning	Shows the Deskew Tuning OSD (Only on AMX 5121/5130 switch - based platforms
	with skew card).
enable serial force	Enables this mode. Can also be performed via OSD Lockdown Tab, but must be
mode	performed via command line if only local AMIQ modules are connected.
disable serial force	Disables this mode. Can also be performed via OSD Lockdown Tab, but must be
mode	performed via command line if only local AMIQ modules are connected.