Configuring the ATS Network Management Interface

Connect the ATS to your network

1.Connect a CAT-5 network cable to the surge-protected ethernet port on the user connection plate. The arrow in the illustration below is pointing to the port. The figure on page 11 shows the location of the user connection plate on the roof of the ATS.

You can make this connection from inside the enclosure, or you can remove the user connection plate from the ATS to make the connection. A Phillips or standard screwdriver is needed to loosen the two captive screws. Use the knockout in this plate to route the cable. If you decide to remove the plate, make sure not to disturb the existing connections.

2.Run the connected CAT-5 network cable through the

knockout in the user connection plate to your network connection.

3.Configure the TCP/IP settings of the ATS (see “Configuration overview” on page 52 for further instructions).

InfraStruXure Power Generation System

51

Page 61
Image 61
American Power Conversion 250 A manual Configuring the ATS Network Management Interface, Connect the ATS to your network