How to Add Sub-Feed Output Distribution Circuit Breakers to the ATS

Circuit breaker adapter modules available from APC

Adapter modules are required when mounting breakers onto the panel bus in the ATS. Each adapter module can accommodate two breakers.

APC’s adapter modules are sized to fit all of the circuit breaker types described on the previous page: T1 single-pole breakers, T1 three-pole breakers, and T3 three-pole breakers. Two types of T1 single- pole adapters are offered: one that plugs into either L1 or L3, and one that plugs into L2. When adding single-pole breakers, try to keep the loads balanced among L1, L2, and L3.

PGT11PADAP

T1 single-pole adapter module for plugging into L1 or L3

PGT1L21PADAP

T1 single-pole adapter module for plugging into L2

PGT13PADAP

T1 three-pole adapter module

PGT33PADAP

T3 three-pole adapter module

 

 

Determine the configuration of the panel

Before installing circuit breakers on the ATS panel bus, be sure enough space is available on the bus. Use the information below and in the next section to determine configurations.

ABB T1 single-pole breakers

T1 single-pole adapter Amount of space available

module

on the 250A ATS

 

Distribution Panel Bus

ABB T1 three-pole breakers

T1 three-pole adapter

module

ABB T3 three-pole breakers

T3 three-pole adapter

module

InfraStruXure Power Generation System

69

Page 79
Image 79
American Power Conversion 250 A manual Circuit breaker adapter modules available from APC