American Power Conversion PD80KF6FK1-M, PD80KG6FK1-M manual Configuring the InfraStruXure Manager

Configuring the InfraStruXure Manager

Connect the InfraStruXure PDU to the InfraStruXure Manager

1.Connect a Cat-5 network cable to the surge-protected ethernet port on the PDU user connection plate.

You can make connections from

inside the enclosure, or you can remove the user connection plate and make your connections.

Remove the plate using a Phillips

or standard screwdriver to loosen the two captive screws. Use the

knockout in the plate to route cables to and from the user

connections on the plate. If you remove the plate, make sure that

you do not disturb the existing connections.

2.Run the connected Cat-5 network cable through the knockout in the user connection plate to the InfraStruXure Manager Hub.

3.Once all APC InfraStruXure-Certified equipment is installed, the network cables are connected to the InfraStruXure Manager Hub, and start-up of the system is complete, configure the InfraStruXure Manager.

For detailed configuration instructions, see the InfraStruXure Manager Installation and Quick-Startmanual included with your InfraStruXure Manager.

See also

44 80kW InfraStruXure PDU—Operation and Configuration