Power up key functions
The table below indicates the function performed when a key is pressed and held while the printer is powered up.
Key | Function |
|
|
FEED | The printer generates a configuration label. See Printing the |
| Configuration Label for details. |
|
|
PAUSE | The printer performs a Calibration test. See Calibration of |
| Media Sensor for details. |
|
|
CANCEL | Pressing this key bypasses any PALTM program that is loaded |
| into the printer and places the printer in its normal mode. |
| This is done before loading a new PALTM program into the |
| printer. If the CANCEL key is not held down then the |
| current loaded application will begin running. |
|
|
Special Power Up Key Function
Enter into Feature Management Mode
Pressing and holding the FEED key until the READY LED flashes one time will establish a communication between the Fastmark 602 PAL printer and a PC.
This communication is only on the SERIAL port of the printer and FeatureMan must be active on the attached PC. Note: Entering into Feature Management Mode automatically establishes the communication parameters (baud rate, parity, etc) and can not be altered. The Printer is also in an OFF LINE state. Pressing the PAUSE button will cancel Feature Management Mode and place the printer
ON LINE.
Disabling a PALTM program
Pressing and holding the FEED key until the READY LED flashes two times will temporarily disable any loaded PALTM program.
Cycling the printer’s power will
ON LINE Key Operation
The table below indicates the functions of a key when pressed after the printer is powered on and in the ready condition.
Key | Function |
|
|
FEED | No function. |
|
|
PAUSE | Places the printer Off Line. |
|
|
CANCEL | No function |
|
|
Fastmark 600 Series User's Guide | 35 |
