AMT Datasouth 600 manual Setup Feature and Value List, Feature Name Value Range Description

Setup Feature and Value List

FEATURE NAME	VALUE RANGE	DESCRIPTION
Media Type	[ Direct Thermal, Thermal Transfer ]	Set to Thermal Transfer if ribbon is used.
Media Sensing	[Gap, Continuous, Black Bar ]	Set to match media sensing method.
Calibrate Media	(Form Length / Gap Length)	Click the Enter button to initiate the media
	automatically displayed and are not	calibration. The detected media length and
	adjustable from this feature.	Gap are displayed. Not required when
		Media Sensing is set to Continuous
Sensor Threshold	[ 0-255]	Automatically set by Calibration mode.
		The lower the number the less sensitive the
		Sensor is.
Media Length	[ 0.25 - 12.00] (Inches)	Automatically set by Calibration mode.
		Manual change of this values will reflect in
		the Calibrate Media feature.
Media Width	[ 0.5 - 4.05] (Inches, 602)	Set to media width used.
	[ 0.5 - 4.25] (Inches, 603)
Present Distance	[ 0.00 - 1.00 ] (Inches)	The Present Distance is the distance the
		printer will push the label out of the printer
		after printing a label. Typically this feature
		is used to adjust to position of the end of a
		label to the tear bar or the Peel Location
		when the Peel and Present option is
		installed. After setting this feature the
		printer will feed to the top of the next label.
Backfeed	[Enable, Disable]	This feature controls the back feed of
		media.
		When enabled, the printer will reverse the
		label the distance indicated in the Present
		Distance feature.
		When Disabled, the printer will not reverse
		the label and begin printing immediately at
		the current label position. Note: This will
		result in no new printing on the portion of
		the label presented by the Present Distance
		feature.
Present Sensor	[Enable, Disable]	This feature controls the operation of the
		optional present sensor. When installed
		and enabled, the printer suspends printing
		after each label until it is removed by the
		operator. This is typically used when the
		peel and present option is installed but
		could also be used with the tear bar.

Fastmark 600 Series User's Guide 38