AMT Datasouth 600 manual Ribbon Holder Notches and Ribbon Core Slots

3.Rotate the Print Head Module to the vertical position.

4.Verify that the Ribbon Supply Core and the Ribbon Take-up Core have two slots on the left side of the core 180-degree’s apart. If the width of the ribbon is less than the minimum core width or if no slots are present, insert one of the supplied Ribbon Core Adapters into each ribbon core.

5.The Slots in the Ribbon Core should mate to the Notches in the Left Ribbon Supply Holder and the Left Take-Up Holder. If using the Ribbon Core Adapter, the adapter’s notches will mate with the slots in the Ribbon Holders.

Note: The notches are the drive mechanism and the ribbon out reporting for the ribbon. If the slots for the Ribbon Core are not correct, contact your ribbon supplier to obtain the correct ribbon. If you need the Ribbon Core Adapter, contact your printer supplier.

Ribbon Supply Holder

Ribbon Supply Core and

Take-up Core

Ribbon Notch Location Core Slots

Figure 11 – Ribbon Holder Notches and Ribbon Core Slots

Fastmark 600 Series User's Guide 20