Other User Detected Errors
The following issues may be detected by the user but may not reported by the printer to the Feature Management Mode.
Description of Issue | Possible Problem | Possible Correcting Procedures | |
|
|
|
|
No power or | Printer not attached to a | 1. | Verify Power Plug on back of printer is pushed firmly |
LEDs are not on | power source. |
| in. |
|
|
| |
|
| 2. | Verify Power Adapter is connected to a known power |
|
|
| source. |
|
| 3. | See Maintenance Manual for procedure of verifying |
|
|
| and changing of the fuse. |
|
|
|
|
| Power Switch is not in the | 1. | Verify Switch is in the ‘1’ position. |
| on position. | 2. | Toggle switch to verify both off and on condition. |
|
| ||
|
|
|
|
| Is the printer in FeatureMan | 1. | Press the PAUSE key to see if the Ready LED comes |
| mode? |
| on. |
|
| 2. | Cycle Power on the printer. |
|
| 3. | Replace the printer. |
|
|
|
|
Media not feeding | Media Latches not closed. | 1. | Open the Top Cover. |
properly |
| 2. | Verify Media is installed according to the Loading |
|
| ||
|
|
| Instructions. |
|
| 3. | Press firmly on the top of the Printhead Mechanism |
|
|
| and verify the both the right and left latches are locked. |
|
| 4. | Close the Top Cover. |
|
|
| |
| Media not installed | Verify Media is installed according to the Loading | |
| correctly | Instructions. | |
|
|
|
|
Media is drifting to | Media Guides not in the | 1. | Open the Top Cover. |
the right as it comes | proper position. | 2. | Verify Media is installed according to the Loading |
out of the printer. |
| ||
|
| Instructions. | |
|
|
| |
|
| 3. | Verify that the right Media is in the proper Position. |
|
|
| The media needs to be snug between the left and right |
|
|
| guides. |
|
|
|
|
Fastmark 600 Series User's Guide | 73 |
