Anritsu ME7840A manual Technical Details, Cal Specification Files, ME 7840A OMM

TECHNICAL DETAILS CAL SPECIFICATION FILES

Table A-1.Technical Details of Calibration Specification Files (5 of 9).

2.sp and Hot S22 (S Parameters & Hot S22)

SP_START Header Details

SP_END

Header Section Keywords:

ncal	Number of calibration sequences of this type to run.
npts	Number of frequency points to use during the calibration sequence. Increasing
	this number will increase calibration time.
	Legal values are (3, 15, 51, 101, 201, 401, 801, 1601 only)
	NOTE: Illegal value causes software to default to 51.
con	Connector sypes for Port 1 and Port 2: Options:
	MN, FN - Male/Female N type
	MK, FK - Male/Female K
	MS, FS - Male/Female SMA
if	IF bandwidth: Legal values are 10, 30, 100, 300, 1000, 3000, 10000, 30000
	NOTE: Illegal value causes software to default to 1000.
avgs	Averages: (Optional). Software will set averaging to value (and turn on) during cal.
pow	Source power setting: during cal, Source 1.
switch	Setting for test set. Correponds to 0￿15 settings.
Detail Section Keywords:
CAL, 1	First calibration
cal type	Type of calibration to perform:
	12 - 12 term
	RR - Reflection Reverse
	RF - Reflection Forward
	8T - 1 Path 2 Port Forward
	8R - 1 Path 2 Port Reverse
	FT - Transmission Frequency Response
<name>	Name for Hot S22
<hot>	For Hot S22 only. Value = offset in kHz of 2nd Source

A-6 ME 7840A OMM