Anritsu ME7840A Installation - Hardware, ME 7840A OMM, Vnms - Front, Test Set - Front, Circulator

INSTALLATION - HARDWARE INSTALLATION

Step 3. Install the four RF cables between the rear of the MS462XC and the Test Set. Torque the cables to 8 inch-pounds (SMA Connectors) or 12 inch-pounds (Type N connectors). Table 2-1 lists the applicable connectors by designation or function.

Table 2-1.RF Cable Connection

VNMS - FRONT		TEST SET - FRONT
PORT 1	Connects To:	“TO PORT 1”
PORT 2		“TO PORT 2”
PORT 3		“TO PORT 3”

TEST SET - FRONT		DEVICE UNDER TEST
	Connects To:
TEST PORT 1		DUT INPUT
TEST PORT 2		DUT OUTPUT

VNMS - REAR		MS4782X -REAR
PORT a1		PORT a1
	Connects To:
PORT a2		PORT a2
PORT b1		PORT b1
PORT b2		PORT b2

MS4782D TEST SET - REAR		CIRCULATOR
C1	Connects To	Circulator 1 or C2
C2	(See Figure 1-2 for a block diagram)	Circulator 2 or C1
C3		Circulator 3 or Open

Step 4. Install the control cable between the External I/O connector on the rear panel of the MS462XC and the Control In connec- tor on the rear panel of the Test Set.

Step 5. Connect the GPIB cable from IEEE-488.2 connector on the rear panel of the MS462XC to the PC/System Controller. (Note: This cable is not supplied with the ME7840A PATS.)

Step 6. Connect an AC power cord to each of the three-prong connec- tors on the rear panel of the Test Set and the MS462XC.

Step 7. (Optional, for drain current PAE measurements) Connect the current probe cable BNC connector to the Ext. Analog In con- nector on the rear of the MS462XC as shown in Figure 2-4(page 2-5).

2-4 ME 7840A OMM