Anritsu ME7840A manual Technical Details, Cal Specification Files, ME 7840A OMM

TECHNICAL DETAILS CAL SPECIFICATION FILES

Table A-3.Technical Details of Calibration Specification Files (7 of 9).

3.powsweep (Power Sweep ￿ IMD mode or 2-tone mode):

POWSWEEP_START Header

Details

POWSWEEP_END

Header Section Keywords:

ncal	Number of calibration sequences of this type to run.
npts	NOTE: npts is IGNORED. Always uses 3, which refers to number of frequency values
	allowed (must be 3 in current software).
if	IF bandwidth: Legal values are 10, 30, 100, 300, 1000, 3000, 10000, 30000
	NOTE: Illegal value causes software to default to 1000.
avgs	Averages: (Optional). Software will set averaging to value (and turn on) during cal.
pow	Start power level for sweep: Set on for Source 1 and Source 2.
switch	Setting for test set. Correponds to 0￿15 settings.
Detail Section Keywords:
CAL, 1	First calibration
name	Name of *.cal file to save when calibration sequence completes.
f1	Start frequency in MHz for global calibration
	NOTE: Set a wide frequency range. Miminum value is 10; ensure f1 is less
	than 2.
f2	Stop frequency in MHz.
Example	Refer to Figure A-2(page A-12).

A-8 ME 7840A OMM