Anritsu Chapter Performance Verification Procedure, 6-1, Test, ME7840A OMM, Introduction, Step

Chapter 6

Performance Verification

Procedure

6-1

6-2

INTRODUCTION	The following are the specific tests that should be used to verify the per-
	formance of the Power Amplifier Test System (PATS)
	￿ Source Output Level Accuracy Test
	￿ Return Loss Measurement Confidence Test
	￿ System Dynamic Range Test
	￿ Receiver Magnitude Display Linearity Test
CONVENTIONS	In the tests in this chapter, instructions will direct use front panel hard
	keys and softkeys. The hard keys and softkeys will appear in a different
	typeface. For example:
	Step 1.	Press the Utility key and select:

DIAGNOSTICS

TROUBLESHOOTING

MORE

VERIFY ALC CALIBRATON

	The Utility key is a front panel hard key and DIAGNOSTICS, TROUBLE-
	SHOOTING, MORE, and VERIFY ALS CALIBRATION are all softkeys.
6-3 TEST	The following equipment is required to performthe verification proce-
EQUIPMENT	dures.
	￿ ANRITSU Model ML243XA Power Meter
	￿ ANRITSU Model MA247XA Power Sensor
	￿ ANRITSU Model 3653 or 3753LF N connector Calibration Kit
	￿ ANRITSU Model SC5237 6 dB Offset Termination
	￿ ANRITSU Model SC5270 20 dB Offset Termination
	￿ ANRITSU Model 11N50B Power Divider
	￿ ANRITSU Model 3670NN50-2 Cable
	￿ ANRITSU Model 34NN50A Adapter
	￿ ANRITSU 2100-2 GPIB cable

ME7840A OMM 6-1