
Appendix B Details of Initialization Command Functions
B.l Initializing Bus
IFC:Initializes functions of all the devices connected the GPIB bus line, when the GPIB option is mounted.
Initialization of the interface function refers to an action of canceling the status of the interface function of the device set by the controller and returning it to the initial status. Each function inarked with a check mark (4)in the table is initialized. The function marked with a delta (A) means that the function will be partially initialized. This command has no effects on the operation status of the device.
Table
I | No. | / | Function |
|
I | I | I | Source handshake | 1 |
1 | 2 | 1 | Acceptor handshake | 1 |
1 | 3 | 1 | Talker or extens~ontalker | 1 |
4Listener or extension listener
5Service request
1 | 6 | 1 Remote local | 1 |
7Parallel port
8Device clear
9Device trigger
10 Controlle
Cord |
| Initialization bv IFC | 1 |
SH | 1 | d | I |
AH | 1 | V | I |
T o r T E | 1 | \I | I |
L or LT |
| v |
|
SR | 1 | A | I |
RL |
| ||
PP |
|
|
|
DC |
|
|
|
DT |
|
|
|
C |
| d |
|
The following table shows changes in status of the device by the IFC message.
| Table |
| |
IFC Message | Changes in Status of Device |
TalkerListener | All the talkers and listeners switch into the idle state (TIDS and LIDS) within 100 ps. |
Controller | Unless the controller is active (SACS: System control Active State), the controller switches |
| into the idle state (CIDS: Control IDle State) within 100 ps. |
Device of service request Although the state where the device is sending an SRQ message to the controller (state where the SRQ line is set by the device to the LOW level) is not canceled, the message cancels the state where the controller have all the devices under the system bus in the serial pole mode.
- | - |
D e v ~ c eIn remote mode Dev~cescurrently In the remote mode will not be released from the remote inode by the IFC me\sage.