Anritsu MP1777A operation manual Setting GPlB, GPlB Interface, Jitter Setting Equalizer, Clock

Section 2 GPlB Interface

2.5Setting GPlB

To use GPIB as a remote interface, set the device to the local mode and set the address by performing key input on the

front panel.

	Table 2-5 Details of Setting when GPlB lnterface is Used
Details of Setting	I	Setting Item	Setting Range
Address setting		Address	0 to 30

Perform the setting shown above on the Secondary system screen in the h h i n setup screen.

(1)(a) Pressing the Setup key causes the Main setup screen to open.

The Main setup screen has "Setup" indicated on the left top section of the screen.

S e t u ~ I Interface 1 ITx&Rxl			Time XX : XX : XX XWXXWXX
Bit Rate	[	2,488 M	]
Jitter Setting: Equalizer	[	OFF	]
Clock	[	Internal	]

Fig. 2-3Main setup Screen

(b)Moving the cursor to the shaded section of the figure above and pressing the Setup key causes a window as shown below to open. To select the Secondary system screen, move the cursor onto "System" using the cursor key and press the Set key.

Fig. 2-4Screen Selection Window