APC Battery Management System manual Select Remotely over the network, and click Next

Battery Management System

USER’S GUIDE

®

Run the Wizard to perform the configuration. To discover and configure, over the network, installed or embedded Network Management Cards that are not configured:

1.From the Start menu, launch the Wizard. The Wizard automatically detects the first Network Management Card that is not configured.

2.Select Remotely (over the network), and click Next >.

3.Enter the TCP/IP settings (System IP, Subnet Mask, and Default Gateway) for the unconfigured Network Management Card identified by the MAC address at the top of the screen. Then click Next >.

4.On the Transmit Current Settings Remotely screen, if you check- mark Start a Web browser when finished, the default Web browser connects to the device that contains the Network Management Card after you transmit the card’s settings.

5.Click Finish to transmit the TCP/IP settings. If the IP address you entered is in use on the network, the Wizard prompts you to enter an IP address that is not in use. Enter a correct IP address, and click Finish.

6.The Wizard searches for another installed or embedded but unconfigured Network Management Card. If it finds one, it displays the screen with data entry boxes for the TCP/IP settings of that card.

–To skip configuring the card whose MAC address is currently displayed, click Cancel.

–To configure the TCP/IP settings of the next card, repeat this procedure beginning at step 3.

156