APC Battery Management System manual Use the Wizard, Launch the Wizard

Battery Management System

USER’S GUIDE

®

Use the Wizard

Launch the Wizard

The installation creates a shortcut link in the Start menu that you can use to launch the Wizard.

Configure the basic TCP/IP settings remotely

Prepare to configure the settings. Before you run the Wizard, be sure that you have the information you will need during the configuration procedure:

1.Contact your network administrator to obtain valid TCP/IP settings to use.

2.If you are configuring multiple unconfigured Network Management Cards, obtain the MAC address of each one so that you can identify each Network Management Card that the Wizard discovers. (The Wizard displays the MAC address for a discovered card on the same screen on which you then enter the TCP/IP settings.)

–For Network Management Cards that you install, the MAC address is on a label on the bottom of the card.

–For embedded Network Management Cards, the MAC address is on a label on the device containing the card — for example, usually on the side of a device that you mount in a rack.

You can also obtain the MAC address from the Quality Assurance slip that came with the Network Management Card or with the device containing an embedded Network Management Card.

155