Setup 5-13MN1854
Configuring JOG Low Velocity [ JLr ]
EDIT > SETUP > JOG > LO–VEL
Value: 2.0 {Velocity Units}
Range: 0.0–9,999,999.0
– Axis One JOG Lo–Vel –
←2.0 in/s →
Sets the low speed JOG velocity. Use the numeric keys to enter a
value (units were selected in the SETUP > MECH > VEL menu).
Select value, press ENTER
Press ← or → to select next axis.
Configuring JOG Low Velocity [ JHr ]
EDIT > SETUP > JOG > HI–VEL
Value: 5.0 {Velocity Units}
Range: 0.0–9,999,999.0
– Axis One JOG Hi–Vel –
←5.0 in/s →
Sets the high speed JOG velocity. Use the numeric keys to enter a
value (units were selected in the SETUP > MECH > VEL menu).
Select value, press ENTER
Press ← or → to select next axis.
Configuring JOG Enable [ JEi ]
EDIT > SETUP > JOG > ENABLE
Value: Enabled
Range: Disabled or Enabled
– Axis One JOG Enable –
←Enabled →
Enables or disables JOG features. When disabled, an error
message is displayed when the jog buttons are pressed. JOG is
often disabled after installation to prevent access.
Select value, press ENTER
Press ← or → to select next axis.
Configure HOME Parameters
The homing function combines the flexibility of a customized homing routine with
the ease of use of calling a “canned program”. (Also see the GH command).
Action Display Comments
Press F3 (HOME) for more sub
menu selections. –↑SETUP↓–
I/O JOG HOME
Select a sub–menu, press F1 (I/O), F2
(JOG), or F3 (HOME).
Press ↓key for more sub menu
selections. –↑HOME SETUP↓–
MODE EDGE SWITCH
Select a sub–menu, press F1 (MODE),
F2 (EDGE), or F3 (SWITCH).
Press ↓key for more sub menu
selections. –↑HOME SETUP↓–
OFFSET DIR
Select a sub–menu, press F1
(OFFSET) or F2 (DIR).